abc home living 25700 Manuel D'instructions page 10

SAVE THESE INSTRUCTIONS
This section provides step-by-step instructions for installation of your fireplace.
NOTE
This fireplace insert does not require venting.
Make sure the fireplace insert is switched off.
WARNING
The outlet must be 16A/230V.
CAUTION
Do not remove the four rubber feet at the bottom of the fireplace insert or install the fireplace insert directly on soft
surfaces, which may restrict air circulation. Otherwise, it may cause a risk of fire or damage.
Don`t place the fireplace to close to the wall. The fireplace must have a least 10cm distance away from the
wall.
Select a suitable location, which is not susceptible to moisture, safe, dust free, away from high traffic and away from
things may catch fire or block openings such as drapes, furniture, etc.
CAUTION
Store your fireplace insert in a dry, safe and dustless place when placing the mantel or building the wall
construction.
WARNING
Do not attempt to wire you own new outlets or circuits. To reduce the risk of fire, electric shock or injury to persons,
always use a licensed electrician.
OPERATING INSTRUCTIONS
Control Panel
Master Power Switch (A)
Open the cover and push button A down (I) to "ON" position.
ON/OFF(B)
Press button B(ON/OFF) to begin the flame effect. Default interface displays as following:
⚫
The heating icon will display and start heating when the room
temperature is less than the default setting (10°C), on the contrary
it will not display and heat.
⚫
The clock icon will be flashing because the time is not set yet.
Please follow the steps in "Time Setting" to set the time.
Two short beeps that increase in pitch sound when switched on and three beeps that decrease in pitch sound when
switched off. When switches on, the heating level, set temperature and clock icon are displayed. The display will be
disappeared after 60 second without any operation. Press any button to display again.
Locking the Buttons(C)
Press and hold button C(OK) for more than 6 seconds to lock or unlock the buttons, LOC is displayed and indicated
that the buttons are locked. Once it's locked LOC will be flashing for 6 seconds then disappear, press any button LOC
will flash again. Long press button C(OK) for 6 seconds to unlock the buttons. Please note the button B(ON/OFF) is
never locked.
Heating ON/OFF
Heating Mode Quick Start
Press button E(+) or F(-) to quick start heat setting(Even though it's under weekly program) as following:
a. Press either button E(+) or F(-) to see the current temperature on screen.
b. Press button E(+) or F(-) to adjust the temperature as desired. Press button C(OK) to validate the setting. If the
set temperature is higher than the room temperature detected by appliance, the heating starts. The heating will
not start if the set temperature is lower than the room temperature.
NOTE: The temperature range including OFF and from 10°C to 30°C. OFF for no heating, 10°C to 30°C is the
selectable temperatures and ON for continuous heating
.
GB2