uebe cyclotest baby Mode D'emploi page 76

Technical information
Temperature
display:
Measurement
range:
Measuring
accuracy:
Storage and trans-
port conditions:
Serial number:
Battery:
Service:
Calibration:
Additional equipment connected to medical electrical equipment must comply with
the respective IEC or ISO standards (e.g. IEC 60950 for data-processing equipment).
Furthermore, all configurations shall comply with the normative requirements for medical
systems (see IEC 60601-1-1 or Section 16 of the 3rd edition of IEC 60601-1, respect-
ively). Anybody connecting additional equipment to medical electrical equipment is a
system configurer and is therefore responsible for ensuring that the system complies with
the normative requirements for systems. Attention is drawn to the fact that local laws
take priority over the above-mentioned normative requirements. If in doubt, consult your
local specialised dealer or the Technical Service department.
Absolute in °C (non-extrapolating)
35.5 - 38.0 °C
±0.1 °C at ambient temperature 10 °C to 35 °C, rel. air humidity
up to 85 % (non-condensing)
Ambient temperature -10 to +50 °C
Rel. air humidity up to 85 % (non-condensing)
Protect against moisture/humidity
The unit has a serial number which is identified with SN:
please quote this number in the event of possible service
enquiries.
RENATA type CR2450N button cell, battery for approx. 500
measurements, battery to be replaced only by UEBE Medical
GmbH. The unit may only be repaired by the manufacturer or
by an expressly authorised organisation.
Should your unit show evidence of a fault, we ask you not to
attempt repairs yourself, but instead to send the unit with a
short description of the fault directly to UEBE Medical GmbH for
inspection, as unit parts cannot be repaired individually.
The unit does not have to be calibrated; the metrological accur-
acy of the unit will be automatically checked when the battery
is replaced by UEBE Medical GmbH.
EN-76