Panasonic EY46A2 Instructions D'utilisation page 13

Using a cut-off disc guard
(Available as an accessory, not
included)
Make sure the side.
WARNING
• When using an abrasive cut-off disc,
be sure to use only the cut-off disc
guard designed for this use with
cut-off disc.
• NEVER use cut-off disc for grinding.
• Do not jam the Disc or apply
excessive pressure. Do not attempt
to make an excessive depth of
cut. Overstressing the cut-off
disc increases the loading and
susceptibility to twisting or binding
of the cut-off disc in the cut and the
possibility of kickback, cut-off disc
breakage and overheating of the
motor may occur.
• Do not start when disc is in the
workpiece. To do so causes the
cut-off disc binding or kickback. Let
the cut-off disc reach full speed and
then carefully cut the workpiece.
• During cutting operations, never
change the angle of the disc. Placing
side pressure on the cut-off disc
(as in grinding) will cause the disc
to crack and break, causing serious
personal injury.
CAUTION
• To prevent excessive temperature
increase of the tool surface, do not
operate the tool continuously using
two or more battery packs. The tool
needs cool-off time before switching
to another pack.
• Do not close up ventilation slots
on the sides of the body during
operation. Otherwise, the machine
function is adversely affected to
cause a failure.
• Do not strain the tool (motor). This
may cause damage to the unit.
01̲Eng̲EY46A2(EU).indd 13
• Use the tool in such a way as to
prevent the air from the ventilation
slots from blowing directly onto your
skin. Otherwise, you may get burned.
1. Clamp nut
1
2. Cut-off disc
Indicator lamp for On lock
3. Disc flange
4. Spindle
2
start prevention function
3
The grinder will not start when the
battery pack is inserted with the switch
4
at the ON position (switch lever at ON).
The warning lamp will flash at this
time to indicate that the 'On lock start
prevention function' has operated.
Press the switch to the OFF position
(switch lever at OFF) and then press it
back to the ON position (switch lever at
ON) to start the grinder.
- 13 -
ON→OFF OFF→ON
2014/07/02 12:01:23