LaMotte WaterLink Spin Touch Mode D'emploi page 8

¬ Gently wipe smudges from the screen with the Cloth Wipe (3580-WIPE).
¬ Do not touch the screen with a sharp object.
¬ Do not place objects on the screen that will scratch or damage it.
¬ Avoid touching the screen with wet fi ngers.
TESTING
1. Press and hold until the meter turns on.
2. Tap . Select a sanitizer type. Tap
3. Tap . Select a disk series (found on disk packaging). Tap
NOTE: Disk Series are limited by Sanitizer Type selection.
4. Remove a disk from the packaging.
5. Use the syringe (1189) to fi ll the disk with the pool or spa water sample.
6. Insert the disk. Cover the disk with the Universal Disk Cover. Close the lid.
7. Tap to start test. Tap
8. The results will be displayed.
9. Choose an option.
¬ Tap
¬ Tap the highlighted
not enabled.
¬ Tap the hightlighted
Printer.
¬ Tap the highlighted
¬ Tap to return to the Test Screen.
10. Press and hold
NOTE: For water samples over 100 °F (38 °C) subtract 0.3 from pH result or, for the most accurate
result, wait until water sample is below 90 °F (32 °C) to test.
Sani zer
Salt
Disk Series
203
30-Oct-18
12:14 AM
to cancel the test.
to add a tag.
to save the test results to the test log if Auto Save is
to send the results to the enabled Mobile Bluetooth
to send the results to a Bluetooth enabled device.
for 2 seconds to turn the meter off .
Tap to
Start Test
to confi rm.
8
to confi rm.