Replacing The Cartridge Of The Smartclean System - Philips S91 Série Mode D'emploi

Replacing the cartridge of the SmartClean system

2
1
When the cleaning program is done, the ready
symbol lights up continuously.
30 minutes after the cleaning program and
charging are done, the SmartClean system
switches off automatically.
The battery symbol lights up continuously to
indicate that the shaver is fully charged. Charging
takes approx. 1 hour.
Note: If you press the on/off button of the
SmartClean system during the cleaning program,
the program stops. In this case, the cleaning or
drying symbol goes out.
Note: If you disconnect the SmartClean system
from its power source, the cleaning program stops.
Replace the cleaning cartridge when the
replacement symbol flashes orange or when you
are no longer satisfied with the cleaning result. If
you clean the shaver in the SmartClean system
once a week, the SmartClean cartridge lasts
approximately three months.
1 While holding the SmartClean system with one
hand, press the button on the side of the
SmartClean system and lift the top part of the
SmartClean system.
2 Remove the cleaning cartridge from the
SmartClean system and pour out any remaining
cleaning fluid.
You can safely pour the cleaning fluid down the
sink.
3 Discard the empty cleaning cartridge.
27
English