User Manual - Velleman NETBPEM3 Mode D'emploi

1. Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle could
harm the environment. Do not dispose of the unit (or batteries) as unsorted municipal waste; it
should be taken to a specialized company for recycling. This device should be returned to your
distributor or to a local recycling service. Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for choosing Velleman! Please read the manual thoroughly before bringing this device into service. If
the device was damaged in transit, do not install or use it and contact your dealer.
2. Safety Instructions
Indoor use only. Keep this device away from rain, moisture, splashing and dripping liquids.
 Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and the
dealer will not accept responsibility for any ensuing defects or problems.
 This energy meter is designed for appliances of 5 W ~ 3680 W (max. current 16 A). Make sure not to
connect any appliance exceeding these limits as the meter may overload and cause personal injuries or
damage.
 Connect this meter to a 230 V~, 50/60 Hz mains only.
 This meter is for indoor use only. Never use it in open air.
 Only use the meter for its intended purpose. All other uses may lead to short circuits, burns, electroshocks,
crash, etc. Using the meter in an unauthorised way will void the warranty.
 Note that damage caused by user modifications to the device is not covered by the warranty.
 This energy meter must be grounded at any time.
 Operate this meter at an ambient temperature between +10° C to +40° C. High temperatures may cause
the meter to overheat and damage both the meter and the connected appliance.
 Do not use the meter near flammable gases, vapour and dust, or in wet and damp environment.
 Disconnect the device from the mains to clean it or when it is not in use.
 Do not connect on a modified sine wave inverter.
 Familiarise yourself with the functions of the meter before actually using it. Do not allow operation by
unqualified people. Any damage that may occur will most probably be due to unprofessional use of the
meter.
 Keep the device away from children and unauthorised users.
 Never insert objects into the meter.
 Do not use a damaged or deformed meter.
3. General Guidelines
Refer to the Velleman® Service and Quality Warranty on the last pages of this manual.
4. Programming the Meter
Before connecting any appliance, the condensers inside the energy meter must be fully charged during 12 h. To
do so, connect the energy meter to the mains. Note that the LCD will light up after 5 minutes. At this
time, you can start programming your meter.
V. 03 – 29/09/2016
NETBPEM3/NETBSEM3

USER MANUAL

2 ©Velleman nv