Setup - Sun Microsystems 365-1383 Mode D'emploi

Getting Started
!º Video input 2 connector (HD15)
Inputs RGB video signals (0.700 Vp-p, positive) and
SYNC signals.
5 4 3 2 1
10 9
15 14
Pin No. Signal
1 Red
2 Green
(Composite
Sync on Green)
3 Blue
4 ––
5 DDC Ground*
6 Red Ground
7 Green Ground
* Display Data Channel (DDC) Standard of VESA
6
8 7 6
13 12 11
Pin No. Signal
8 Blue Ground
9 DDC + 5V*
10 Ground
11 ––
12 Bi-Directional
Data (SDA)*
13 H. Sync
14 V. Sync
15 Data Clock(SCL)*

Setup

Before using this monitor, check that the following items are
included in your carton:
• Monitor (1)
• These operating instructions (1)
Step 1: Connect the monitor to the
computer
With the computer switched off, connect the video signal
cable to the video output of the computer.
to a computer with an
HD15 video output
to a computer with a
13W3 video output
Note
Do not short the pins of the video signal cable.
Step 2: Connect the power cord
With the monitor switched off, connect one end of the
proper power cord for your local supply to the monitor and
the other end to a power outlet.
to a power outlet to AC IN
Power cord
Step 3: Turn on the monitor and computer
The installation of your monitor is complete.
Note
If "OUT OF SCAN RANGE" or "NO INPUT SIGNAL" appears on
the screen, see "Warning Messages" on page 18.