Hama HOME X10CD Mode D'emploi page 11

4.2.4 Reverse run mode
NOTE!
►
■ Slide the operating switch (1) to the "Rev/On CD" position. The
rollers of the paper cutting system rotate in the opposite direction.
■ Slide the operating switch (1) to the "On/Auto" position.
■ Switch approximately three times successively between the posi-
tions "Rev/On CD" and "On/Auto".
■ Switch off the device and remove the jammed paper or plastic card
from the feed shaft (2).
4.2.5 Emptying the bin
■ To switch the device off, slide the operating switch (1) to the "Off"
position.
■ Lift the cutting attachment off of the waste bin (5).
■ Empty the bin.
■ Place the cutting attachment back onto the waste bin (5).
4.2.6 Switching off the device
■ Slide the operating switch (1) to the "Off" position.
Home X10CD
These modes serve to remove any blockages in the cutter
system.
g
11