Télécharger Imprimer la page

TOPRO TROJA NEURO Série Manuel D'utilisation page 10

Publicité

Les langues disponibles
  • FR

Les langues disponibles

EN
Important to know about safety before use
Take care when folding and unfolding to ensure not to injure your hands or fingers.
Check the brakes before use, and that the rollator locks into position when opened.
Not to be used by persons heavier than the maximum user weight (see table).
Do not use to transport heavy loads or persons.
The rollator is not a toy and therefore should be treated in an appropriate manner.
Make sure that the lock wheel for height adjustment for the handles is locked tightly.
Be aware! Some parts of the rollator might feel hot or cold when exposed to extreme temperatures.
Do not alter the product as this might put your safety at risk and the guarantee will not be void.
Important to know about safety when in use
In order to move the rollator, the brake handles must be pushed in A.
In order to brake, release the brake handles. This activates the parking brake B.
The parking brake is always activated, when you do not push in the brake handles, to prevent the rollator
from rolling away C.
Do not lean or bend sideways or over the back of the rollator whilst in the seated position D. Do not tilt the
rollator more than max. 5° sideways, to avoid risk of falling. Due to the same reason bags etc. must never be
hung on the handlebars.
To give the right support and safety, make sure the rollator is kept as close to your body as possible E.
Walk straight, look forward and hold your backside in F. That is the easiest way to keep your balance.
Do not push the rollator too far from your body as this can cause unnecessary strain and you could fall G.
Do not use the rollator on stairs. Be careful when descending kerbs.
Be careful of flared skirts and trousers as they could get caught in the wheels, which could lead to falling.
We therefore recommend not wearing flared/wide clothing.
For safety reason it is prohibited to sit on the rollator during public transportation. Place your rollator securely.
NB! For rollator models with laser light unit: Do not look directly towards the laser beam, as this may cause
injuries on your eyes.
Assembling / adjusting
TOPRO TROJA NEURO is delivered assembled. Before use, you must unfold the rollator. The height of the handlebar
tubes will then need adjusting to suit the user's needs.
Unfolding / folding
Unfolding: Loosen the lock clamp that is over the seat bars A. Press the seat bars down and out B. The side frames
will slide apart. Press down the seat bars. You will hear a clicking sound. The rollator is now locked in its open position.
Folding: Pull the strap on the seat C and press the side frames together. Lock the clamp D over the seat bars.
Lowering and height adjusting the handles
Lowering: Unscrew the lock wheel for the brake handles A (approx. 4–5 turns). Push the handlebar tubes down
until they stop B. Tighten the lock A again.
Height adjusting: Unscrew the lock for the brake handles A (approx. 4–5 turns). Adjust the handlebar tubes to
a suitable height then pull them slightly up and down C until you hear a clicking sound. Tighten the lock A again.
Adjust both handlebars to the same height. It is recommended that the handlebars are set to the same height as your
wrists when your arms are hanging alongside your body.
Height adjustment using the memory function
You have the opportunity to set the height of the handles at a standard setting fitted to your requirements so that
you easily can find the same height again. Decide the height of the handlebars. Count visible holes at the back of
the handlebar tubes. Unscrew the lock wheel A. Pull the tube B out of the frame. The attached part C will now follow
the handlebar tube. Move the attached part C on the tube B so the amount of holes corresponds to the amount
counted earlier. Fit the memory chip D on the handlebar tube in the first available hole under the attached part C.
Push the handlebar tube B down and into the side frame E until the attached part is locked. Screw the lock wheel
A half in. Pull the handlebars F up until they stop and then tighten the lock wheel A properly. From now on, when
the handlebars are in the lowest position, they will stop in the preset position automatically when pulled up.
8
3
www.topro.no
TROJA NEURO
2
4
5
EN

Publicité

loading

Ce manuel est également adapté pour:

Troja neuro mTroja neuro s