Your All-Purpose Cutter; Cleaning - Bosch MAS40 Série Mode D'emploi

Your all-purpose cutter

Before using the appliance for the first time,
clean thoroughly.
Please fold out the illustrated pages.
W Risk of electric shock!
Do not use the appliance near a sink filled
with water!
X Fig. 1 and 2
■ Place the appliance on a smooth, clean
surface and press down firmly so the
rubber feet are sucked on, preventing
slipping.
■ Fold down the table and lock
(MAS41.. only).
■ Assemble the carriage, attach vertically
in the side guide groove and place on
the table.
X Fig. 3
■ Adjust the cutting width with the knob.
W Risk of injury from sharp blade!
Blade is very sharp. Keep hands clear of
the blade. After switching off, the drive
continues for a short time. After work, set
cutting width to 0.
X Fig. 4 and 5
Instantaneous switching
■ Press switch-on safety device. Simulta-
neously press ON button until the power
tool starts running.
■ Release the switch-on safety device
again.
■ To stop the appliance, release the
ON button.
Continuous operation (MAS41.. only)
■ Press switch-on safety device. Simul-
taneously press ON button until it locks
into position.
■ Switch-on safety device can now be
released.
■ To stop the appliance, press the
ON button again and release.
X Fig. 6
Speed control (MAS41.. only)
■ Controls the cutting speed. If food
is very soft (e.g. cheese), set speed
to MIN.
MAS40_MAS41_8001024687.indb 9
X Fig. 7
Stainless steel circular blade
X Fig. 8
■ Attach the remnants holder, cut. Always
use the carriage and remnants holder!
Notes:
■ Cut sausage and cheese first and bread
last. The appliance is then easier to
clean.
■ For reasons of hygiene, the appliance
and the blade should be cleaned
immediately after slicing greasy
food (e.g. meat, sausage, cheese).
X "Cleaning"

Cleaning

The appliance requires no maintenance!
Thorough cleaning guarantees a long
service life.
W Risk of electric shock!
Never immerse the appliance in water or
place under running water and do not clean
in the dishwasher.
W Risk of injury from sharp blade!
Before cleaning the appliance, pull out the
mains plug and remove the blade. Do not
grip the blade by the cutting surface, but by
the blade attachment.
Caution!
Surfaces may be damaged. Do not use
abrasive cleaning agents.
■ Wipe the appliance and attached parts
with a damp cloth and then a dry cloth.
Cleaning the circular blade
■ Thoroughly clean the circular blade after
each use by hand.
X Fig. 10
■ Fold up the table and take out of the
hinge to the right.
X Fig. 7
■ Rotate the blade holder in a clockwise
direction and place vertically. Then take
out the circular blade.
English en
9
16.12.2015 16:21:33