Operation - Husqvarna LC 141VLi Manuel D'utilisation

2. Remove the knob, washer, and screw on the left and
the right side.
3. The handle can be set to 2 different heights. Put the
screw in one of the 2 holes on the left and the right
side.(Fig. 37 )
4. Attach the screws, washers and knobs.
5. Move the knobs up in the direction of the handle until
they stop and you hear a click. Tighten the knobs
fully.(Fig. 38 )
To assemble the grass catcher
1. Push the 2 transportation covers out and down.(Fig.
39 )
2. Put the top part of the grass catcher onto the lower
part of the grass catcher. Attach the grass catcher
frame with the clips.(Fig. 40 )
Introduction
WARNING: Before you operate the product,
you must read and understand the safety
chapter.
To set the product in operation position
If the handle is put in transport and storage position (see
To set the product in transport position on page 25 ), do
the procedure that follows to put the handle in operation
position.
1. Lift the handle until the lower handle locks into
operation position.(Fig. 43 )
2. Move the lower knobs up in the direction of the
handle until they stop and you hear a click.(Fig. 44 )
3. Tighten the knobs.
4. Lift the upper handle and tighten the knobs.(Fig. 45 )
To set the cutting height
1. Move the cutting height lever rearward to increase
the cutting height.
2. Move the cutting height lever forward to decrease
the cutting height.(Fig. 46 )
CAUTION: Do not set the cutting height too
low. The blades can hit the ground if the
surface of the lawn is not level.
Battery
WARNING: Before you use the battery, you
must read and understand the safety
chapter. You must also read and understand
the operator's manual for the battery and the
battery charger.
20
3. Lift the rear cover.
4. Attach the hooks on the grass catcher to the top
edge of the chassis.(Fig. 41 )
To assemble the mulching-kit
1. Lift up the rear cover and remove the grass catcher.
2. Put the mulch plug into the grass discharge channel.
The mulch plug of type A is for LC 141Li and
LC 141C. Type B is for LC 141VLi.(Fig. 42 )
3. Close the rear cover.
4. Replace the blade with the Combi blade, see
remove and replace the blade on page 23 .

Operation

Battery status
The display shows the remaining battery capacity and if
there are problems with the battery. The battery capacity
is shown for 5 seconds after the product is switched off
or the battery indicator button is pressed. The warning
symbol on the battery is on when an error has occurred.
Battery on page 24 .
See
(Fig. 47 )
LED lights
All LEDs are lit
LED 1, LED 2, LED 3 are
lit
LED 1, LED 2 are lit
LED 1 is lit
LED 1 flashes
To charge the battery
Charge the battery before the first use. The battery is
only 30% charged when supplied to the customer.
Note: The battery charger must be connected to the
voltage and frequency specified on the rating plate.
The battery does not charge if the battery temperature is
above 50°C. The battery charger decreases the
temperature of the battery before it starts to charge.
1. Connect one end of the power cord for the battery
charger into the socket of the battery charger.
To
Battery status
Fully charged (75-100%)
The battery is 50%-75%
charged
The battery is 25%-50%
charged
The battery is 0%-25%
charged.
The battery is empty.
Charge the battery.
71 - 005 - 18.05.2018