Attaching The Camera And Spacer To The Tray - Bosch UHI-SBG-0 Manuel D'installation

12 en | Installing the Housing
5.5

Attaching the Camera and Spacer to the Tray

The UHI-SBG-0 includes two (2) spacers which may be required to keep the camera level (see
Figure 5.7 on page 12). If a spacer is not used, the camera may dip down creating a port hole
effect.
Camera and Spacer Installation
1.
2.
3.
4.
Fig. 5.7 Attaching the Camera and Spacer to the Tray
5.
6.
September 15, 2006 | F01U032279_01
Attach the lens to the camera.
Tentatively place the camera tray inside the housing. Do not secure.
Determine if one of the supplied spacers are required and place on top of the lower por-
tion of the tray as seen in Figure 5.7 on page 12.
Place the camera in the up-right position inside the housing with the lens approximately
1/8 in. away from the housing window (lens should not touch window).
Hold all three (3) components in place (tray, spacer, and camera) and remove from hous-
ing. Turn components over and secure with 1/4-20 x 5/8 in. screw and large flat washer.
Set aside.
Installation Manual
UHI-SBG-0 Series
Bosch Security Systems, Inc.