Makita DF010D Manuel D'instruction page 6

Guideline for clutch auto-stop
Work range of clutch auto-stop
High speed
Clutch auto-stop works
Clutch auto-stop
does not work
When driving machine
screws
Lighting up the front lamp
B
► 1. Lamp switch
Increments on adjusting
ring for fastening torque
Low speed
Increments
1 - 3
4 - 8
9 - 18
19 - 21
A
1
1
5
9
13
17
21
Guideline for machine screw diameter
2.5 mm (3/32")
3 mm (1/8")
4 mm (5/32")
5 mm (3/16")
► 1. Lamp
CAUTION:
• Do not look in the light or see the source of light
directly.
To turn on the light, slide the lamp switch to the A position.
To turn off the light, slide the lamp switch to B position.
Even if you leave the lamp on, the light will automati-
cally turn off after 5 minutes.
6 ENGLISH
Fastening torque
Approx. 0.3 N m
.
(Approx. 0.2 ft lbs)
Approx. 0.82 N m
.
(Approx. 0.6 ft lbs)
Approx. 1.35 N m
.
(Approx. 1.0 ft lbs)
Approx. 1.88 N m
.
(Approx. 1.4 ft lbs)
Approx. 2.41N m
.
(Approx. 1.8 ft lbs)
Approx. 2.9 N m
.
(Approx. 2.1 ft lbs)
Low speed
Approx. 5 N m
.
(Approx. 3.7 ft lbs)
High speed
Approx. 1.5 N m
.
(Approx. 1.1 ft lbs)
1