Christopeit Sport RUNNER PRO MAGNETIC Notice De Montage Et D'utilisation page 20

Step 5:
Installation of the handrail (29) on the left and right supports
(24+33).
1. Put one curved washer 8//20 (60) on each screw M8x45 (13).
2. Place the hand rail (29) to the upper ends of the left and right
supports (24+33) so that the holes are align with the threat ho-
les in supports (24+33).
3. Push the screws (13) with washers (60) through the holes and
screw in firmly.
4. Push the ends of the sensor connection cable 1 (68) (projecting
from the right support (24)) and sensor connection cable 2 (31)
(from handrail (29)) together.
Step 6:
Installation of the computer (30) at handrail (29) and drink
bottle holder (56) at support (24).
1. Take the computer (30) that has been supplied out of the pa-
ckaging and insert the batteries (Type "AA"-1.5 V pen cells) by
watching for the right polarity on the back of the computer (1).
(Batteries for the computer are not included in this item. Please
buy them at your located market.).
2. Place the computer (30) on the computer bracket at the middle
of the handrail (29) and align the holes in the computer with the
holes in the bracket.
3. Screw the screws (49) with washers (51) through the holes and
tighten firmly.
4. Plug the end of the sensor connection cable 2 of handrail (31)
into the associated socket of the computer (30).
5. Insert the plug of the hand pulse (14) in the likewise correspon-
ding socket of the computer (30).
6. Put the bottle holder (56) at the handlebar support (24); fix it
with two screws M5x15 (67) and washers 5//10 (71) at appro-
priate position and insert the bottle (55) into the bottle rack (56).
7. Place the handle cover (27) onto the screw connection of hand-
rail (29).
20