Christopeit Sport RUNNER PRO MAGNETIC Notice De Montage Et D'utilisation page 18

Assembly Instructions
Before beginning assembly, be sure to observe our recom-
mendations and safety instruction. Remove all the part of your
cycle from the carton and place them on the floor carefully.
Some parts are pre-assembled. Assembly time: 35 - 45 min.
Step 1:
Installation of the left and right support (24+33) at bottom fra-
me (23).
1. Place the screws M8x50 (58) and screw M8x55 (50), the
washers 8//16 (59) and the nuts M8 (19) accessibly beside the
bottom frame (23).
2. Lift up left side of bottom frame and put in the two screws (58).
3. Place the left support (33) on the foot and align so that the hole
patterns in the foot are aligned.
(Note: The transport rollers (21) pre-assembled in the bottom
frame (23) must point backwards (opposite to the line of sight
when standing on the machine during training. Right and left
are specified as viewed standing on the machine during trai-
ning.)
4. Push on each screw end of screw (58) a washer (59) and tighten
with nut (19).
5. Put the screw (50) through the holes and tighten with washer
(59) and nut (19) too.
6. Proceed as described in 2. – 5. with the right support (24) on the
right hand side of the foot (23).
Step 2
Installation of cable (25) and cover (38) at main frame (1).
1. Put the tension cable (25) into the receiver of the base frame (1)
and insert the end of tension cable (25) into the base of magnet
(18). Secure the position of the tension cable (25) by screwing
the nut at the end of the tension cable in the indicated arrow
direction. (See figure 1-3)
2. Screw the cover (38) at main frame (1) tightly, by using screws
M6x10 (47) and washers 6//12 (69).
18