EUROM MILANO de LUXE Manuel D'instructions page 16

START AND WORKING
Make sure that fan, power cable and plug are not damaged and that
the voltage complains with the specifications on the label of the fan.
Plug in.
• By pushing the ON/OFF-button of the control-panel or the
remote-control you set the fan in use. The display shows the
indoor temperature and the fan-speed: standard low.
• With the SPEED-button you arrange the fan-speed. At the start it
is low; by pressing the SPEED-button you heighten it to middle,
and by pressing another time to high. Do you press again the
speed will come back to low.
• With the MODE-button you choose for a not-constant fan speed
which imitates a natural wind. The fan alternates weak-, middle-
and strong 'gusts of wind'. By using at the same time the SPEED-
button you can set three variants of this mode: weak- middle- and
strong natural wind.
• By pressing the MODE-button another time you change to the
SLEEP-mode, which you (by the SPEED-button) also can set in
three variants:
- sleep-mode high: SPEED on high, MODE on SLEEP. The first
30 minutes the fan will produce strong natural wind, after that 30
minutes a middle natural wind and than it switches to weak
natural wind till the fan is turned off.
- sleep-mode middle: SPEED on middle, MODE on SLEEP. The
First 30 minutes the fan will produce a middle natural wind, than
it switches to weak natural wind till the fan is turned off.
- sleep-mode weak: the fan produces a weak natural wind till it is
turned off.
• With the TIMER-button you set beforehand a limit to the
workingtime of the fan. By pressing one time the TIMER-button
you set half an hour; every time you press again you add another
half an hour, till 8 hours (16 times pressing). When you press for
th
the 17 time, you deactivate the timer.
16