Publicité
Les langues disponibles
Les langues disponibles
3. Assembly of the blade
• Insert the motor shaft into the fan blade
to the uttermost so that the rotating pin
falls in total in the groove at the backside
of the blade.
• Anti-clockwise clock the blade cap into
the motor shaft and fix it tightly, as
illustrated.
4. Assembly of the front guard
• Place the frontguard over the backguard. Start in the top by
hanging the 'hanger' of the frontguard over the middle-up rib of
the backguard. Fasten now carefully the guardring over the
backguard, from up to dowm, with the build-in clamps. Make
sure that the ring encircles perfect the both gurads.
• Close the transparent guard clip under the front guard ring and
lock the locking screw.
• To remove the front guard you have to open at first the screw,
then open the guard clip.
• Pat the right and left part of the guards at the same time with your
hands, to start at the downside, at the clip.
THE REMOTE CONTROL
Battery assembly instruction
Open the cover of battery compartment.
1.
Install two batteries into the battery compart-
2.
ment. Take care on the polarity of battery.
Cover up the battery compartment.
3.
Using the remote control
• The remote controller should be pointed to the receiver.
• Please make sure to used the remote controller is within
approximately 5 meters from the receiver. If not, the effectiveness
will be reduced.
14
Publicité
