Setting The Audio Delay; Setting The Auto Surround Mode; Setting The Ext. In Subwoofer Level; Setting The Power Amp Assignment - Denon AVR-1706 Mode D'emploi

ENGLISH
Advanced Setup

Setting the Audio Delay

• When watching a DVD or other video source, the picture on the
monitor may seem delayed with respect to the sound. In this
case, adjust the audio delay to delay the sound and synchronize
it with the picture.
• The audio delay setting is stored separately for each input
source.
CURSOR F F G G
Press the or button to set the delay
ENTER
time, then press the or
switch the Auto Surround Mode setting.
With a movie source, for example, adjust so that the
movement of the actors' lips is synchronized with the sound.
* A . D e l a y
0ms 100ms
• The audio delay setting does not apply when playing in the EXT.
IN mode or in the analog input direct mode or stereo mode.
• By default, this menu is not displayed when no digital signals
are being input.

Setting the Auto Surround Mode

The surround mode used last for the three types of input signals
shown below is stored in the memory, and the signal is
automatically played with that surround mode the next time it is
input.
Note that the surround mode setting is also stored separately for
the different input sources.
q Analog and PCM 2-channel signals (STEREO)
w 2-channel signals in the Dolby Digital, DTS or another multi-
channel format (DOLBY PL
CURSOR H H
button to
e Multi-channel signals in the Dolby Digital, DTS or another multi-
channel format (DOLBY/DTS SURROUND)
Default settings are indicated in ( ).
Press the
Surround mode, then press the
H H
button to switch the Ext. In Subwoofer Level
0 m s
setting.
200ms
II x Cinema)
CURSOR F F G G
or button to select the Auto
ENTER CURSOR
or
* A u t o S u r r . O N
ON OFF
43
ENGLISH

Setting the Ext. In Subwoofer Level

Set the method of playback of the analog input signal connected
to the EXT. IN terminal.
CURSOR F F G G
Press the or button to select the ext. in
subwoofer channel level playback, then press the
CURSOR H H
ENTER
or button to switch the Power
Amp Assignment setting.
* E x t . I n S W + 1 5 d B
+0dB +5dB +10dB

Setting the Power Amp Assignment

Make this setting to switch the power amplifier for the surround
back channel to ZONE2.
SPEAKER OUT
Power Amp
Assign.
MAIN ZONE
Surround back 7.1ch system
ZONE2 5.1ch system
CURSOR F F G G
Press the or button to select "S. Back"
ENTER
or "ZONE2", then press the
button if you want to start the settings over from the
beginning.
* P . A m p S . B a c k
S.Back
Advanced Setup
+15dB
ZONE2
–
2ch system
CURSOR H H
or
ZONE2