If The Refrigerator Cannot Pass Through A Door During Installation, Follow These Steps - Zanussi ZRS9600FA Notice D'emploi

If the refrigerator cannot pass through a door during installation, follow these steps

Removing Freezer Door
Remove front bottom cover fi rst, if it is attached.
1. Remove the bottom cover fi rst. Pull out the left collar
of the coupling fi rst, then hold the coupling and pull
out the left water tube. (Dispenser Models Only)
2. Unscrew top hinge cover with a screwdriver.
3. Turn top hinge fastener counterclockwise
3~4 times. Disconnect the harness wires.
4. Lift up the front of hinge to remove. (After the hinge is
removed the door can fall down forward. Be careful!)
44
5. Be careful not to damage the water line when
removing the door.
Removing Refrigerator Door
1. Unscrew top hinge cover with a screwdriver.
Insert a thin screwdriver into the side groove of the
cover to remove.
2. Turn top hinge fastener counterclockwise
3~4 times. Disconnect harness wires.
3. Lift up the front of hinge to remove. (After the hinge is
removed the door can fall down forward. Be careful!)