Zanussi ZRS9600FA Notice D'emploi page 47

3. Remove any substances in the fi lter
• Open the main tap water valve and check if water
comes out of the Water Tube.
• Check if the Water Valve is open in case water
does not come out.
• Leave the valve open until clean water is coming
out.
Initial water may contain some substances
–
out of fi lter (manufacturing process).
4. Attach the Filter Box
• Screw and fasten the fi lter holder to the left/right
side of the back of refrigerator.
In case the holder is not fastened well,
–
remove the back paper of the tape on the fi lter
holder and attach it.
• Insert the fi lter box into the holder.
5. Connect the Water Tube to the refrigerator
• Remove the rear cover at the bottom back of the
refrigerator.
• Insert the fastening ring into the Water tube. (Be
careful to follow the direction of the nut.)
• Insert the Water Tube into the top of the Water
Valve, turn the nut clockwise to fasten it. (The
Water valve is to the right of the motors.)
• Check for any bent tubes or water leaks; if so,
re-check installation procedure.
• Replace the rear cover. (The Water Tube should
be placed between the groove of the refrigerator
back and motor cover.)
Set the tube upright as the fi gure shows.
Water
Tube
6. Fasten the Water Tube
• Fasten the Water Tube with the [Fastener A].
• Check if the tube is bent or sqeezed. If so, set it
right to prevent any water leak.
Fastener A
Water Tube
7. After installation of Water Supply System
• Plug in the refrigerator, press the [WATER]
button on the control panel for 2~3 minutes to
remove any air (bubble) in the pipes and drain
out the initial water.
• Check for the water leaks again through the water
supply system (tubes, connectors and pipes).
Rearrange the tubes again and do not move the
refrigerator.
Tap
Connector
Water Tube
Water Tube
Nut
Water Valve
47