ECG VP 3143 S Mode D'emploi page 36

OPERATING INSTRUCTIONS
VACUUM CLEANER ASSEMBLY
Before you start assembling the vacuum cleaner, it must be turned off and disconnected from power.
Connect and disconnect hose
• Connection: Insert hose into the suction hole in the housing of the
vacuum cleaner. Push the end in until it clicks.
• Disconnect: Unplug the appliance from the power supply, press the
locks on the sides of the hose's end and pull out the hose from the
suction opening.
The telescopic tube assembly and installing the accessories
1. Insert the telescopic tube into the vacuum cleaner handle.
2. Adjust the telescopic tube to a suitable length: Press the pin lock and pull out the bottom part to desired
length. If you want to lock the tube in the set length, simply release the lock.
3. Fasten the fl oor brush or the combination nozzle to the telescopic tube.
GB
VACUUMING
1. Pull pull out the necessary length of the power cord and plug it in
the wall outlet. The yellow mark indicates the maximum length of the
power cord. Never pull the power cord past this mark.
2. Start the appliance by pushing the button
vacuum cleaner.
3. If you want to retract the cord, press button
with the other hand hold the cord to prevent damage or injury by
uncontrolled rewinding.
Power control
You can set the suction power of the appliance by using the motor power
control located on the body of the vacuum cleaner. For cleaning fi ne
materials we recommend that you set the minimum power. For mattresses,
upholstered furniture and carpets set medium power. When cleaning paved, wooden or other hard fl oors, use
the maximum power.
After use
Turn off the vacuum cleaner and unplug the power cord from the outlet. Before you add any accessories or
before cleaning the appliance, always turn the vacuum cleaner off and unplug it from the outlet.
CLEANING AND MAINTENANCE
You will fi nd instructions in this manual for routine maintenance of the vacuum cleaner. To ensure long life
and service of the vacuum cleaner without problems, check regularly the hose, the dust bag and fi lters of the
vacuum cleaner. Remove dirt from clogged hose, replace full dust bags and clean dirty motor fi lter.
36
in the back of the
with one hand and