Emptying The Debris Compartment - Hayward AquaVac 250 Manuel D'utilisation

EMPTYING THE DEBRIS COMPARTMENT

WARNING!
Using the robot without its filter cover in place will VOID your warranty.
In order to maximize the cleaning efficiency, clean the debris compartment and the filter cover
before and after each use.
CAUTION! Before cleaning the debris compartment, make sure the robot is OFF.
1. Place the cleaner on a flat surface. Pull one side clip outwards to lift one side of the cover
and repeat the steps on the other side to lift the entire top cover to expose the filter cover and
filter plate.
2. Detach the filter cover and remove the debris from the compartment. It is recommended to
clean the filter cover net with splashing water. If brushing is deemed necessary, use only a
soft brush to clean it carefully and gently to avoid any damage.
3. After cleaning, make sure that filter cover is in place and the top cover is correctly installed
and secured by the side clips.
CAUTION!
- Replace a damaged filter cover immediately with a new one before the next operation.
- Replace a damaged flap immediately with a new one before the next operation.
14