Consumer Information And Safety; Operating The Cleaner - Hayward RC34 Série Guide De L'utilisateur

• •
⚠ DANGER
⚠ WARNING
⚠ CAUTION
⚠ WARNING
⚠ WARNING
⚠ CAUTION
⚠ WARNING
⚠ WARNING
⚠ CAUTION
Keep the power supply control in shaded area.
The power supply control is equipped with an automatic shut off to prevent over heating if operated in direct sunlight.
Caution: use the original power supply box only.
HAYWARD only warranties the quality, performance and safety of its products when assembled with genuine
Hayward manufactured parts. Use of non-genuine Hayward manufactured parts will void all warranty.
Page 4 of 20
WARNING: Electrical Hazard. Failure to follow
instructions can result in serious injury or death.
FOR USE WITH RESIDENTIAL SWIMMING POOLS

CONSUMER INFORMATION AND SAFETY

Risk of electrical shock or electrocution
The electrical supply to this product must be installed in accordance with all applicable
local codes and ordinances (see page 20). Improper installation will create an electrical
hazard which could result in death or serious injury to pool users or others due to electrical
shock, and may also cause damage to property.
Do not play with cleaner or cable or apply to body. Can trap or tear hair or body parts.
Cable can trip or entangle swimmers, which could result in drowning.
Before installing the cleaner, understand cleaner coverage. The cleaner was not designed
to automatically clean steps or to work under a solar cover. It was also not designed to do
initial cleanup for a new pool installation.
Always stay out of the pool while cleaner is in operation or in the pool.

OPERATING THE CLEANER

A 30 mA differential protection device (RCD) must be installed to protect your electrical
outlet and to prevent any possible electric shock. Failure to do so could create an
electrical hazard which could result in death or serious injury to pool users or others due
to electrical shock and may also cause damage to property.
DO NOT switch the pool cleaner to "ON" if it is not immersed in the water. Operating the
cleaner out of the water may cause severe damage and will result in loss of warranty.
Always remember to turn off the power supply "OFF" and unplug it from the power outlet
before removing the cleaner from the pool.
It is mandatory to allow a safety distance between the power supply and the pool as
required by the current installation standard (3.5 m minimum).
Do not use an extension cord to connect to the power supply.
Power supply heat sink surface may be hot.
Rev. C