Stihl BGA 85 Notice D'emploi page 7

Keep the handles dry and clean –
–
free from oil and dirt – for safe
control of the power tool.
Never attempt to modify the controls
–
or the safety devices in any way.
Check condition of impeller
–
housing.
A worn blower housing (cracks, nicks,
chips) may result in an increased risk of
injury from thrown foreign objects. If the
blower housing is damaged, consult
your dealer – STIHL recommends you
contact a STIHL servicing dealer.
To reduce the risk of accidents, do not
operate your power tool if it is not
properly assembled and in good
condition.
During Operation
In case of imminent danger or in an
emergency, switch off the motor
immediately, move retaining latch to ƒ
and remove the battery.
Your power tool is designed to be
operated by one person only. Do not
allow other persons in the work area.
Keep bystanders, especially children,
and animals away from the work area.
To reduce the risk
of injury from
thrown objects, do
not allow any other
persons within a
radius of 5 meters
of your own
position.
BGA 85
To reduce the risk of damage to
property, also maintain this distance
from other objects (vehicles, windows).
Do not direct the air blast towards
bystanders or animals since the air flow
can blow small objects at great speed.
When blow-sweeping (in open ground
and gardens), watch out for small
animals to avoid harming them.
Never leave a running machine
unattended.
Walk slowly forwards as you work –
observe the nozzle outlet at all times –
do not walk backwards – risk of
stumbling.
Hold your power tool in a normal,
relaxed working position. Make sure you
always have good balance and secure
footing.
Take care in slippery conditions – on
slopes and uneven ground.
Watch out for obstacles: Be careful of
refuse, tree stumps, roots and ditches
which could cause you to trip or stumble.
Never work on a ladder or any other
insecure support.
Work calmly and carefully – in daylight
conditions and only when visibility is
good. Stay alert so as not to endanger
others.
To reduce the risk of accidents, take a
break in good time to avoid tiredness or
exhaustion.
Static electricity may build-up while
blow-sweeping large quantities of very
dusty material and suddenly discharge
in certain unfavorable conditions (e.g.
very dry work area).
If dust levels are very high, always wear
a suitable respirator.
Never attempt to insert objects into the
impeller housing through the intake
screen or the nozzle. They may be
expelled at very high speed by the
blower – risk of injury.
If there is a noticeable change in running
behavior (e.g. higher vibrations), stop
work and rectify the cause of the
problem.
If your power tool is subjected to
unusually high loads for which it was not
designed (e.g. heavy impact or a fall),
always check that it is in good condition
before continuing work – see also
"Before Starting Work". Make sure the
safety devices are working properly. Do
not continue operating your power tool if
it is damaged. In case of doubt, consult
your servicing dealer.
Before leaving the power tool
unattended: Always switch off the power
tool, set the retaining latch to ƒ and
remove the battery.
After Finishing Work
Always clean dust and dirt off the power
tool – do not use any grease solvents for
this purpose.
Vibrations
This power tool minimizes the vibrations
transmitted to the operator's hands.
However, the operator should seek
medical advice in the event of suspected
circulatory problems in the hands (e.g.
tingling sensation in the fingers).
English
5