Ferm JSM1014 Traduction De La Notice Originale page 7

ASSEMBLy
3
Before assembly, always switch off the
machine and remove the mains plug
from the mains.
Mounting and removing the saw blade (fig. B)
Refer to the table below to select the required
saw blade.
Saw blade
Coarse
Medium
Fine
Very fine
2
Do not attempt to remove the guard from
the machine.
Mounting
● Slacken the Allen screw (13) using the Allen
key (11).
● Insert the saw blade (14) in the saw blade
holder (6) as far as possible. The teeth of the
saw blade (14) must point upward and
forward. The smooth side of the saw blade
must engage in the slot of the guide roller (15).
● Tighten the Allen screw (13) using the Allen
key (11).
removing
● Slacken the Allen screw (13) using the Allen
key (11).
● Remove the saw blade (14) from the saw
blade holder (6).
● Tighten the Allen screw (13) using the Allen
key (11).
Mounting and removing the parallel guide
(fig. C)
The parallel guide is used for sawing along edges
at a maximum distance of 16 cm.
Mounting
● Slacken the locking bolts (8).
● Insert the parallel guide (16) into the saw shoe
(7).
● Set the parallel guide (16) to the required
position.
● Tighten the locking bolts (8).
removing
● Slacken the locking bolts (8).
● Remove the parallel guide (16) from the saw
shoe (7).
● Tighten the locking bolts (8).
Material
Wood
Wood
Steel, aluminium, plastic
Wood (curves)
USE
Switching on and off (fig. A)
● To switch on the machine, press the on/off
switch (1).
● To switch the machine to continuous mode,
keep the on/off switch (1) pressed and
simultaneously press the lock-on button (2).
● To switch off the machine, release the on/off
switch (1).
Setting the sawing speed (fig. A)
The speed adjustment wheel is used for setting
the sawing speed. The speed adjustment wheel
can be set to 6 positions. The ideal sawing speed
depends on the profile and the teeth of the saw
blade and on the material to be worked.
2
Do not set the sawing speed during use.
● Turn the speed adjustment wheel (3) to the
required position.
● For hard materials, use a saw blade with fine
teeth and select a lower speed.
● For soft materials, use a saw blade with
coarse teeth and select a higher speed.
Setting the mitre angle (fig. D)
The mitre angle is variable between 0° and 45°.
2
Do not set the mitre angle during use.
● Slacken the Allen screws (17) using the Allen
key (11).
● Tilt the saw shoe (7) to the required position.
● Tighten the Allen screws (17) using the Allen
key (11).
Using the pendulum action switch (fig. A)
The pendulum action switch is used to set the
way in which the teeth of the saw blade grip the
material. The pendulum action switch can be set
to 4 positions.
2
Do not set the pendulum position during
use.
● Turn the pendulum action switch (4) to
required position according to the material to
be worked. Refer to the table below to select
the required position.
7