Wavemaster TWO Mode D'emploi page 11

• Switch on the main switch on the back.
Switching ON/STANDBY as well as VOLUME control of your sound system can be done by the
•
front control knob of the right speaker box.
• Adjust the BASS and TREBLE level by the controls at the rear panel, if required.
If you emphasize the bass control too much, the maximum total volume will be limited since the
woofer may run at overstroke earlier. Please care not to overstroke the woofer too much
(audible distortions) since this can reduce the life-span of the woofers!
AUDIO SIGNAL SENSING: if the input signal is very low or off for more than 10 minutes, the
•
audio signal sensing automatically switches to STANDBY. Once there is an audio signal, the
audio signal sensing automatically switches ON again!
This technology is beneficial with many sources, especially with any kind of wireless sources
such as Airplay (WLAN) or Bluetooth audio systems: you can operate the wireless audio source
and the speaker system activates or deactivates according to the provided audio signals.
Due to the various power supply provided by the
power and mains power output sockets, the audio signal sensing enables very comfortable
operation and perfect integration of your
installations!
Audio Configurations
The following configurations show the most typical examples of audio setups for your
speaker system.
Connection to MP3 players (e.g. iPod):
1. For charging your MP3 player while playing, connect the USB cable from the MP3 player to
TWO
USB jack on the
needed on a desktop, for example.
2. Connect the audio cable from MP3 player headphone jack to the
TWO
backside. Use a standard USB extension cable, if extra cable length is
English
TWO
speaker system through the USB
speaker system with your wireless home
11
TWO
TWO
input socket B.