Publicité
Les langues disponibles
Les langues disponibles
Assembly and operation
Assembly and operation of your
are shown in the following drawing.
Please connect all components only when the mains power switch is switched OFF.
•
Place the speakers at their target area and start connecting.
•
First, connect the left speaker to the right speaker by the speaker cable. The gold-plated
binding posts can be turned and the stripped cable ends shall be fitted to connect red to red
and black to black. Turn the binding posts tight by hand, so that the cables can achieve a good
connection from the output of the right speaker (active) to the left speaker (passive). Please
care to avoid short circuits between red and black connectors, not to cause
malfunctions or defects!
•
Now connect the sockets INPUT A or B on the back to the appropriate stereo sound source,
using the provided audio cable. Please refer the following chapters for some details on the
various sources.
•
The mini phono INPUT A socket at the back is of higher priority than the RCA INPUT B.
Therefore, as long as the source plug is plugged-in to the mini phono socket A, a source
connected to the RCA terminal B is muted. Once you release the plug from mini phono INPUT
A, you can listen to the source connected to the RCA INPUT B again. This enables quick
change from stationary source (connected to RCA INPUT B) to a portable source in INPUT A
without removing the cable of the stationary source connected to INPUT B.
•
Before mains connections, check your mains power system to be appropriate to the
The mains voltage (230V or 115V) of your power system you can set by the VOLTAGE
SELECTOR of your
the mains voltage easily. Attention: if the mains voltage is set wrong, the device may become
defective! Always set the correct mains voltage to avoid defects!
•
Connect the mains cable to toe mains input socket and the Euro plug connect to your mains
supply.
TWO
speaker system is very easy to do. General connections
TWO
(beside the POWER switch) and you can verify the actual setting of
English
10
TWO
.
Publicité
