ECOFOREST PARIS Manuel D'installation Et Maintenance page 45


5.7. Empty the hopper to take remaining pellets out to avoid pellets absorb humidity.
5.8. Cleaning of the pellets drop tube.
Use the brush provided by ECOFOREST to remove the dust until the end of the tube.

Cleaning brush.

Pipe of pellets fall.
5.9. Cleaning of the exhaust circuit of the stove, extractor's collector.
For an optimal cleaning of the extractor's collector, it is recommended to dismantle the extractor itself in
order to have full access to this zone for a better cleaning. Once the extractor is dismantled, clean it with a
dry brush and be careful with the turbine and structure.
The following drawing illustrates model Eco III. What differentiates this stove from the rest is the position of
the extractor.

Gas outlet extractor.

Ceramic fiber joint (replace).
When reassembling the exhaust it is COMPULSORY to replace the exhaust joint with a new one as you run
the risk of gas entering in our home.
5.10. Dismantling and cleaning of gas outlet pipes.
When mounting the gas outlet pipeline, make sure it is well assembled, preferably sealed with silicone. If the
pipe has sealing joints, you must verify its good condition and replace it if necessary.
5.11. Cleaning the dirt which may be accumulated inside the stove, accessing through the back.
5.12. Cleaning the exchanger fins. Remove any dust deposited during the season. The lack of exchanger cleaning
may reduce machine performance.

Drawing 33
44
Drawing 34
Drawing 35