ECOFOREST PARIS Manuel D'installation Et Maintenance page 32

4.5. Easily accessible power socket. If the power socket can't be accessed due to the characteristics of the
electrical installation, an all-pole disconnection switch must be installed.
4.6. The power cable provided by ECOFOREST is 1.4m long; you might need a longer one. Always use a cable with
ground plug and with an equal or greater section. Make sure the power cable is not placed under the stove
or close to hot or sharp surfaces that could damage it.
4.7. Remove the packaging and the protective plastic.
4.8. Remove the screws or bolts that fasten the stove to the pallet and remove it.
4.9. If our model has a plastic protection, it must be removed before starting it.
4.10. Remove the protection of the exhaust gas fan and the convector in the case of ductable stoves.
To remove the gas output cover in models with option for top output, it is necessary to access the inside of
the stove to remove the cover nuts.
Drawing 4
MATERIAL
It will be made of a material
resistant to the aggressive action
of the combustion products, to
condensation and to constant
temperatures of 300 °C. The
material will comply with the
local legislation for
application.
Aluminum, galvanized or iron
pipe.
Insulated double wall pipe.
Elbow Ø80 X 45°
Elbow Ø80 X 90°
T with outlet.
UNPACKING THE STOVE.
MATERIAL REQUIRED FOR INSALLATION.
COMPLIANCE
OBLIGATORY
its
PROHIBITED
OBLIGATORY
RECOMMENDABLE
OBLIGATORY
OBLIGATORY
OBLIGATORY
 ALL.
 ALL.
 Proximity to flammable materials.
 When crossing a forge or partition.
 Outdoor or brick-built chimney installation.
 Insert stoves. See figure 7.
 Relative ambient humidity ≥ 60%.
 Installation in a public facility.
 Potentially accessible to children or people with
mental, physical or sensory disabilities.
 London Model. Exhaust gas connection.
 Tokio and Bolonia models. Exhaust gas outlet
with rear connection
 ALL.
31
Drawing 5
PARTICULARS