Installing The Batteries - Canon Macro Ring Lite MR-14EX Mode D'emploi

Installing the Batteries

Use four AA/R6 batteries.
Recycling Time and Flash Count
Battery Type
AA/LR6 alkaline batteries
Based on a new set of batteries and Canon's testing standards.
The figures are the same for both flash tubes/heads firing or single tube/head
firing.
This applies to both the MR-14EX and MT-24EX.
Note that certain AA/R6 lithium batteries may become extremely hot
in rare cases during usage. Due to safety reasons, do not use
"AA/R6 lithium batteries".
Use a new set of four batteries of the same brand. When replacing the
batteries, replace all four at one time.
10
Open the cover.
1
Slide the battery compartment cover
as shown by the arrow, then flip up
the edge.
Insert the batteries.
2
Make sure the + and - battery
contacts are properly oriented as
shown in the compartment.
Close the cover.
3
Push down the cover and slide it
back.
Recycling Time
Approx. 0.1 - 7 sec.
Flash Count
Approx. 120 - 800