Terminating Operation; Winding Device For Power Cord; Cleaning; Filter - Clatronic CL 3750 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 20

Terminating Operation

1. Press the POWER
button to turn off the appliance.
2. Disconnect the mains plug from the wall socket.

Winding Device for Power Cord

Wind the power cord around the winding device. Insert the plug into the
slots provided.

Cleaning

WARNING:
• Always disconnect the mains plug from the wall
socket before cleaning!
• Make sure no water enters the openings of the appli-
ance during cleaning. Otherwise this might result in an
electric shock or fire.
CAUTION:
• Do not spray the appliance with cleaning agents.
• Do not use a wire brush or any abrasive items.
• Do not use any acidic or abrasive detergents.

Filter

Clean the filter once every 2 weeks, if the appliance is in daily use. If dust
in the filter blocks the ventilation, the efficiency of the appliance is no
longer guaranteed.
1. There is a grille with an internal filter located above the connection for
the exhaust air hose at the back of the appliance.
2. Remove the grille from the appliance and the filter from the grille.
Problem
Possible cause
Appliance does not function.
No power supply
Timer function is activated.
The ambient temperature is too low or too high.
The appliance is defect.
Appliance does not cool suf-
The appliance is exposed to direct sunshine.
ficiently.
Windows or doors are open.
There are too many people or other heating
sources in the room.
The filter is dirty.
The air inlet or air outlet is blocked.
Appliance too noisy during
The appliance is not in an upright position.
operation.
The appliance switches off
The water tank is full.
during operation. The
indi-
cator light flashes red.
The remote control does not
The distance to the appliance is too far.
work.
You are not holding the remote control towards
the sensor.
The batteries are dead.
Display on the appliance: E1
Temperature sensor defective.
Display on the appliance: E2
Contact our customer service or your dealer if you encounter any problems that are not listed in the table or if the recommended remedy does not work.
46
CL3750_IM_neu
3. Vacuum the filter with a vacuum cleaner.
4. Clean the filter under running water. If necessary, use a mild detergent.
5. Allow the filter to air dry in a shady place.
6. Reinsert the filter into the grille once it has dried thoroughly. The re-
cesses point upwards.
7. Reinsert the grille into the appliance.
CAUTION:
Do not operate the appliance without filter!

Housing

• Use a vacuum cleaner to clean the ventilation slots.
• Wipe the housing with a slightly damp cloth.

Seasonal Cleaning and Storage

When not using the appliance for a long period of time, proceed as fol-
lows:
1. Empty the water tank as described above.
2. Repeat the steps 2 to 5 from the chapter "Emptying the water tank"
with the upper water outlet (top plug).
3. Operate the appliance in "Fan" mode for 2 hours in order to dry the
inside of the appliance.
4. Press the POWER
mains plug from the wall socket.
5. Disconnect the flexible exhaust pipe from the appliance.
6. Leave both water outlets open.
7. Clean the filter and the appliance as described above.
8. Cover the appliance with foil.
9. Always store the appliance out of the reach of children in a dry, well
ventilated place.

Troubleshooting

Solution
Check the power connection.
Press the POWER
It is recommended to use the appliance at an ambient temperature
of 16 - 35 °C.
Contact our service department or a specialist. Please consider the
enclosed service manual.
Choose another location or shade the windows.
Close any windows or doors.
Remove portable heaters or switch them off.
Clean the filter.
Remove the blockage. Keep the ventilation openings free from
obstructions.
Place the appliance on a flat surface. Avoid vibrations.
Pull the power plug. Empty the water tank via the lower water
outlet. Then you can use the appliance again.
Move closer to the appliance.
Hold the remote control so it points to the sensor. Make sure there
are no obstacles between the remote control and the sensor.
Replace the batteries.
Contact our customer service or your dealer.
button to turn off the appliance. Disconnect the
button to turn on the appliance.
18.12.2019

Publicité

Table des Matières
loading

Table des Matières