Instructions For Use - Flex CHE 18.0-EC Mode D'emploi

430.013_CHE 18.0-EC.book Seite 16 Mittwoch, 30. September 2015 1:12 13

Instructions for use

Before switching on the power tool
Unpack the power tool and accessories and
check that no parts are missing or
damaged.
NOTE
The batteries are not fully charged on
delivery. Prior to initial operation, charge
the batteries fully. Refer to the charger
operating manual.
Inserting/replacing the battery
 Press the charged battery into the power
tool until it clicks into place.
 To remove, press the release button (1.)
and pull out the battery (2.).
CAUTION!
When the device is not in use, protect the
battery contacts. Loose metal parts may
short-circuit the contacts; explosion and fire
hazard!
16
Battery state of charge
 Press the button to check the state of
charge at the state of charge indicator
LEDs.
If one of the LEDs flashes, the battery must
be recharged. If none of the LEDs light up
after the button is pressed, the battery is
faulty and must be replaced.
The indicator goes out after 5 seconds.
NOTE
Follow the instructions for charging the
battery set out in the charger operating
manual.
Adjusting the auxiliary handle
WARNING!
Remove the battery before carrying out any
work on the power tool.
CAUTION!
Use the power tool with the attached
auxiliary handle only.
The auxiliary handle can be swivelled into
any position to ensure safe and fatigue-free
working.
NOTE!
With the depth stop attached, the pivot
range of the auxiliary handle is restricted.
 Release the clamping by turning the
auxiliary handle counterclockwise (1.).
CHE 18.0 - EC