Reset - DURAVIT 280631 Série Notice D'utilisation

5.4.3 S5: Reset
Refer to page 2 for a graphic illustration of program selection.
> Hold the magnetic key in front of the right signal eye until 8 signal tones sound,
with a longer pause (approx. 6 sec.) between the 5th and 6th, the 6th and 7th and
the 7th and 8th signal tones.
> Remove the magnetic key
The control confirms the program selection by 2 short signal tones.
> To initiate reset, hold the magnetic key in front of the right sensor eye again within
the next 4 sec.
The control confirms the reset by 2 short signal tones.
> Remove the magnetic key.
The control unit has now been reset to the factory settings (defaults).
> Start up the control unit again as described in section 5.1.
29