Publicité
Les langues disponibles
Les langues disponibles
6.
Make electrical connections. (Figure 5.)
N
ote:
Ensure wiring is centered through wire hinge.
Connect supply side line voltage wire to black lead.
●
●
Connect supply side neutral wire to white lead.
●
●
Connect supply side ground wire to green lead.
●
●
Installer must use UL listed wet location approved
N
ote:
wiring connections inside UL listed wet location
junction box (supplied by others).
7 .
After electrical connections are made, push the wire
splices through the center hole of the quick mount
plate. Swing and lift the luminaire into position while
maintaining tension on wire hinge.
N
ote:
Failure to maintain tension may result in the wire
hinge becoming dislodged. The metal tabs on
the quick mount plate will align with openings in
the housing plate. With luminaire lifted in place,
slide the luminaire in the direction of the locking
hinges. A "click" sound will occur when the
luminaire is fully seated.
8.
Pivot both locking hinges back into place and tighten
locking screws to 10 inch-pounds. (Figure 6.)
Rigid or Free-Swing Pendant Installation:
1.
Install UL Listed wet location junction box (Supplied by
others) to pendant pipe (Supplied by others) and run
supply wires down through pendant pipe and into wet
location junction box (Per NEC Guidelines).
2.
Refer to Ceiling/Junction Box Installation steps above to
install.
Figure 5.
Installation Instructions - Quadcast LED
Figure 6.
LED Optical Rotation (Figure 7.)
The LED optical panels can be rotated to provide a range of
lighting distributions.
1.
Loosen the 9/64" Allen Head set screw to allow
rotation of the LED optical panel to the desired
position.
2.
Tighten set screw to 15 inch-pounds once desired angle
is achieved.
Set Screw
11
10
9
8
7
6
Location
Angle
of Degrees
Factory
15°
Pre-set*
1
5°
2
15°
3
30°
4
45°
5
60°
Figure 7.
EATON
IB515002EN
Locking Screws
Angle
Indicator
1
2*
3
4
5
Location
Angle
of Degrees
6
75°
7
90°
8
105°
9
120°
10
135°
11
150°
Installation instructions
3
Publicité
