Connections; Connecting To The Hdmi Terminal; Selecting The Priority Video Output When Connecting Hdmi And Component Video - Pioneer BDP-43FD Mode D'emploi

Connections

Be sure to turn off the power and unplug the power cord from the power outlet whenever making or changing
connections.
This Player is equipped with the terminals/jacks listed below. Find the corresponding terminal/jack on your video
equipment. Using the supplied cable or commercially available cables, connect the video first. Then connect the
audio.
Video terminals/jacks on this Player

HDMI OUT terminal
Higher Quality
 COMPONENT VIDEO
OUTPUT jacks

VIDEO OUTPUT jack
Standard Quality
Audio terminals/jacks on this Player
Digital audio connection

HDMI OUT terminal
Higher Quality

DIGITAL OUT OPTICAL
terminal
Standard Quality
Analog audio connection
Standard Quality AUDIO OUTPUT jacks
Broadband Internet connection
LAN (10/100) terminal

Connecting to the HDMI Terminal

• You can enjoy high quality digital picture and sound through the HDMI terminal.
• For details on digital audio output formats (PCM/bitstream), refer to the digital audio output format selection
table on page 25.
• Use High Speed HDMI ®
not operate properly if other HDMI cables are used.
STEPS
1 Be sure to turn off this Player and the equipment before making any connections.
See right.
2 Firmly connect an HDMI cable (commercially available) to the HDMI terminals (
Rear panel of this Player
Page 10
• When using an HDMI
output, 7.1 ch Digital
Output is available.
Page 10

To HDMI OUT terminal
HDMI cable
(commercially available)
See right.

To HDMI IN terminal
Page 11
Page 11
Projector
Equipment with an HDMI terminal
After connecting
• If desired, connect audio equipment. (Page 11)
• Load a disc and start playback. (Page 14)
Page 11 • Refer to control function with HDMI. (Pages 14 and 21)
Cables when using the control function with HDMI. The control function with HDMI may
AC IN
BDP-43FD
Selecting the priority video output when
connecting HDMI and Component video
When you connect both an HDMI cable and a component cable
to this player, you need to select the priority video output in
"Settings" – "Audio Video Settings" – "Video Out Select". (See
page 21.)
NOTE
• When you connect the player to a Pioneer TV with an HDMI cable
only and the TV is turned on, the video output switches to HDMI
automatically. (The above setting is unnecessary.)
• When you connect the player to a TV with an HDMI cable, "HDMI Video
Out" is set to "Auto". If you don't get a stable image, select the desired
resolution.
When you set "HDMI Video Out" to a setting other than "Auto", you can
only select resolutions that are compatible with the connected TV.
• Refer to "HDMI Video Out" on page 21 regarding the resolutions of the
HDMI video output.
TV AV receiver
 and ).
NOTE
• Audio transmitted in DTS-HD High
Resolution Audio and DTS-HD Master
Audio formats is output from the
HDMI terminal as Bitstream. Connect
an amplifier with a built-in decoder to
enjoy the fine sound quality.
9