Disposal; Manufacturer's Warranty - Dx Tools - Hilti DX 860-HSN Mode D'emploi

The tool remains com-
pressed
(does not extend when
pressure is released).
No fastener is driven.
If these measures fail to remedy the problem, please contact Hilti.

10. Disposal

Most of the materials from which Hilti power actuated tools are manufactured can be recycled. The materials must
be correctly separated before they can be recycled. In many countries, Hilti has already made arrangements for
taking back your old powder-actuated tools for recycling. Please ask your Hilti customer service department or
Hilti sales representative for further information. National and international directives and regulations must be
observed.
The individual parts should be separated as follows:
Part/assembly
Toolbox
Outer casing
Piston
Piston brake
Screws, small parts
Used cartridge strips
11. Manufacturer's warranty – DX Tools
Hilti warrants that the tool supplied is free of defects
in material and workmanship. This warranty is valid so
long as the tool is operated and handled correctly,
cleaned and serviced properly and in accordance with
the Hilti Operating Instructions, and the technical sys-
tem is maintained. This means that only original Hilti
consumables, components and spare parts, or other
products of equivalent quality, may be used in the tool.
This warranty provides the free-of-charge repair or
replacement of defective parts only over the entire lifes-
pan of the tool. Parts requiring repair or replacement
as a result of normal wear and tear are not covered by
this warranty.
Additional claims are excluded, unless stringent
national rules prohibit such exclusion. In particular,
Printed: 08.07.2013 | Doc-Nr: PUB / 5069857 / 000 / 01
Piston sticks in the piston brake.
The piston guide is badly soiled with
dirt and deposits.
No piston fitted.
Piston is broken.
The fastener guide is badly soiled with
dirt and deposits.
A fastener is jammed in the fastener
guide.
Main material
Plastic
Plastic/synthetic rubber
Steel
Steel/plastic
Steel
Steel/plastic
Turn the rotating sleeve and replace the
piston and piston brake
Turn the rotating sleeve and clean the
piston guide if necessary
Fit a piston in the tool.
Replace the piston and piston brake.
Clean the base plate and adjoining parts
with the cleaning brush provided.
Remove the jammed fastener
Avoid shear breakage (see above).
Avoid missing the beam (driving the
fastener into unsupported sheet metal);
mark the position of the beams accu-
rately if necessary.
Recycling
Plastics recycling
Plastics recycling
Scrap metal
Scrap metal
Scrap metal
In accordance with local regulations
Hilti is not obligated for direct, indirect, incidental
or consequential damages, losses or expenses in
connection with, or by reason of, the use of, or inabil-
ity to use the tool for any purpose. Implied warranties
of merchantability or fitness for a particular purpose
are specifically excluded.
For repair or replacement, send tool or related parts
immediately upon discovery of the defect to the address
of the local Hilti marketing organization provided.
This constitutes Hilti's entire obligation with regard to
warranty and supersedes all prior or contemporane-
ous comments and oral or written agreements con-
cerning warranties.
.
.
en
.
9