Accessories; Manufacturers Warranty - Tools; Disposal - Hilti SF 100-A Mode D'emploi

Clean them if necessary using a clean cloth. If the bat-
tery capacity drops below an acceptable level after a
short period of use, we recommend that it be diagnosed
by Hilti.
Maintenance
Check all external parts of the tool for damage and check
that all controls operate faultlessly. Do not operate the
tool if parts are damaged or if the controls do not func-
tion faultlessly. If necessary, your electric tool should
be repaired at a Hilti service centre.

Accessories

Battery removal
Battery release button
If the battery has to be changed, press in the two release
buttons using two fingers and pull the battery out of the
screwdriver.
Battery insertion
Push in the battery as far as it will go. There must be an
audible click.
Only the Hilti SBP10 or SFB105 batteries may be used.
Battery charging
Only the Hilti C7/24, C7/36-ACS, SFC7/18, TCU7/36 or
SBC12H battery charger may be used. Please refer to
the charger operating instructions for the charging
process.
If the SFB105 battery is charged in the old SBC 12 H
charger, a loss of capacity must be expected with this
kind of charging. Full capacity of the battery will be
obtained with the C7/24, C7/36-ACS, SFC 7/18 and
TCU7/36 chargers.
SBP10 or SFB105 battery
Use only the SBP10 or SFB105 batteries.

Disposal

Batteries
The Hilti SBP10 battery has 8 nickel-cadmium cells.
The Hilti SFB 105 battery has 8 nickel-metal hydrid cells.
Both you and Hilti bear the responsibility for recycling of the worn-out batteries in
keeping with environmental protection requirements.
Important: Do not throw worn-out batteries into household waste, a fire or water.
Dispose of the batteries in accordance with national regulations or return them to
Hilti.
6
Printed: 07.07.2013 | Doc-Nr: PUB / 5070586 / 000 / 00
Special insert tools program
Should you require insert tools not included in the stan-
dard program, please contact the Hilti customer service
department or your Hilti representative. Hilti offers a
comprehensive range of special insert tools in profes-
sional quality.
Manufacturers warranty – tools
Hilti warrants that the tool supplied is free of defects
in material and workmanship. This warranty is valid so
long as the tool is operated and handled correctly,
cleaned and serviced properly and in accordance with
the Hilti Operating Instructions, and the technical sys-
tem is maintained. This means that only original Hilti
consumables, components and spare parts may be
used in the tool.
This warranty provides the free-of-charge repair or
replacement of defective parts only over the entire lifes-
pan of the tool. Parts requiring repair or replacement
as a result of normal wear and tear are not covered by
this warranty.
Additional claims are excluded, unless stringent
national rules prohibit such exclusion. In particular,
Hilti is not obligated for direct, indirect, incidental
or consequential damages, losses or expenses in
connection with, or by reason of, the use of, or inabil-
ity to use the tool for any purpose. Implied warranties
of merchantability or fitness for a particular purpose
are specifically excluded.
For repair or replacement, send tool or related parts
immediately upon discovery of the defect to the address
of the local Hilti marketing organization provided.
This constitutes Hilti's entire obligation with regard to
warranty and supersedes all prior or contemporane-
ous comments and oral or written agreements con-
cerning warranties.