Teesa TSA3546 Manuel D'utilisation page 23

Owner's manual
Preparing ingredients
The ingredients to be processed need to be precut (max. 1,5x1,5x1,5 cm cubes), peeled and
pitted if necessary. Please note, very hard skin and pits can damage the blades of the device.
When the ingredients are too big, the device may jam. Prepare the ingredients accordingly.
Add water or other liquid (e.g. milk) if needed.
Using blender
1. Make sure the device is properly assembled and the
speed knob is in OFF position. Connect the device to
power supply mains socket.
3. Speed/mode selection: switch the speed knob to ON position,
the knob illumination ring will start blinking). Now, user can
use one of the available modes:
• Manual mode (smooth rotation speed regulation): rotate
the knob between MIN and MAX position for manual
operation.
• Pulse mode: press the "Pulse" button (function is active as
long as you keep the button pressed in). Release the button
to turn off the function.
• Smoothie mode: press the "Smoothie" button to enable this
mode. The blades operate in intervals. After processing, the
blender will turn off the mode automatically or press the
button again to exit the mode.
• Ice crush mode: press the "Ice crush" button to enable this
mode. The blades work in intervals. After processing, the
blender will turn off the mode automatically or press the
button again to exit the mode.
IMPORTANT: Do not use the blender for more than 2 minutes at a time! Allow motor to cool
before reusing!
OPERATION
2. Insert ingredients into the jar (either through the opening
in the lid or detach the lid - you'd have to detach the jar
from the motor unit beforehand).
23
EN