Understanding The Primary Flight Controls - E-FLITE Blade mCX2 BNF Manuel D'utilisation

W ith the rotor blades spinning at a low level of power, move the rudder (left-hand) stick all the way to
the right. This should cause the speed of the upper main rotor blade to increase, and the speed of the
lower main rotor blade to decrease.
N ext, move the rudder stick all the way to the left. This should cause the speed of the lower main rotor
blade to increase and the speed of the upper main rotor blade to decrease. If both rotor blades are not
responding properly to rudder input, simply reverse the locations of their motor plugs on the 5-in-1
unit.
With both rotor blades rotating in the correct directions and responding properly to rudder inputs, your
Blade mCX2 is ready for flight. But you will need to review the following sections of the manual BE-
FORE proceeding with the first flight.

Understanding the Primary Flight Controls

If you are not familiar with the controls of your mCP X, take a few minutes to familiarize yourself with
them before attempting your first flight.
Throttle
Rudder
Elevator
EN
Ascend
Nose Yaws Left
Forward
14
Decend
Nose Yaws Right
Backward