Philips PerfectCare Performer GC8700 Série Mode D'emploi page 17

Problem
The ironing board cover
becomes wet, or there
are water droplets on the
floor/garment.
Possible cause
There was not enough felt in
the ironing board cover.
Steam has condensed on
the ironing board cover after
a long ironing session.
You have an ironing board
that is not designed to cope
with the high steam rate of
the appliance.
Solution
Put an extra layer of felt material under the
ironing board cover.
Replace the ironing board cover if the foam
or felt material has worn out. You can also
add an extra layer of felt material under the
ironing board cover to prevent
condensation on the ironing board.
Put an extra layer of felt material under the
ironing board cover to prevent
condensation on the ironing board.
English
17