Item Entries; Single Item Entries - Sharp XE-A113 Manuel D'instructions

Error escape function
To quit a transaction due to an error or an unforeseen event, use the error escape function as shown below:
To clear the error state
Transaction
The transaction is voided (treated as a subtotal void) and the receipt is issued by this function. If you have
already entered a tendered amount, the operation is finalized as a cash sale.
3

Item Entries

Single item entries

1. Department entries
The cash register provides a maximum of 50 departments for a merchandise classification. Group attributes,
such as taxable status, are applied to items when they are entered to the departments.
• When using the department keys (for department 1 to 32)
For department 1 to 16, enter a unit price and press a department key. If you use a programmed unit price,
press a department key only.
For department 17 to 32, enter a unit price, press the
programmed unit price, press the
When using a programmed unit price
1
Unit price *
(max. 8 digits)
Please note if you press the same key after using the
example, when you register an item of dept. 17 using the
using the preset unit price, you should use the department code entry key described below for the
dept. 1 item. If you just press the
dept. 17 item.
• When using the department code entry key
Enter a department (dept.) code and press the
you use a programmed unit price, enter a dept. code and press the
When using a programmed unit price
d
Dept. code
(1 to 50)
2. PLU/subdepartment entries
For another merchandise classification, the cash register provides a maximum of 200 PLUs/subdepartments.
PLUs are used to call up preset prices by a code entry. Subdepartments are used to classify merchandise into
smaller groups under the departments. Every PLU and subdepartment has a code from 1 to 200, and should
belong to a department to obtain attributes of that department.
l
E E
D
key and press a department key.
Department key
2
*
D
!
d
d
1
Unit price *
(max. 8 digits)
(In case only preset price entry is allowed.)
1 2
FOR THE OPERATOR
Part Part
D
key and press a department key. If you use a
* 1 Less than the programmed upper limit amounts
When zero is entered, only the sales quantity is
added.
* 2 For the departments 17 through 32, press the
D
key.
D
key, it acts as a repeat entry. For
D
key to register dept. 1 item, it will act as a repeat entry of
key, then enter a unit price and press the
d
key.
* 1 Less than the programmed upper limit
amounts
When zero is entered, only the sales
quantity is added.
key and then an item of dept. 1
d
key again. If
3
Part
33