Installing The Speaker/ Microphone Jacks Cover; Installing The Optional Speaker/ Microphone (Or Headset) - Kenwood TK-2312 Mode D'emploi

INSTALLING THE SPEAKER/ MICROPHONE JACKS COVER

Speaker/ microphone
jack cover
INSTALLING THE OPTIONAL SPEAKER/ MICROPHONE
(OR HEADSET)
Speaker/ microphone locking
bracket
4
If you are not using a speaker/
microphone, install the cover over
the speaker/ microphone jacks using
the supplied M2.6 x 7 mm (black)
screw.
Note: To keep the transceiver water
resistant, you must cover the speaker/
microphone jacks with the supplied
cover.
1 Insert the speaker/ microphone
(or headset) plugs into the
speaker/ microphone jacks.
2 Attach the locking bracket using
the supplied M2.6 x 7 mm (black)
screw.
Note: The transceiver is not fully
water resistant while using the
speaker/ microphone.