Items Supplied And Device Overview; Before Initial Use - DS Produkte 00384 Mode D'emploi

■ Protect the device from heat, naked fl ames, extreme temperatures, persistent mois-
ture, wet conditions and collisions.
■ Do not use any corrosive or abrasive cleaning agents to clean the device. These can
damage the surface.

Items Supplied and Device Overview

Unpack the items supplied and check them for completeness (see the "Items Supplied
and Device Overview" chapter) and possible transport damage. If the device, the mains
plug or the mains cable does have damage, do not use the device(!), but contact our
customer service department.
9
8
7
6

Before Initial Use

Before using the device, remove all packaging materials and any labels that may be on
the device and are used for protection during transportation or for advertising.
Assembly
1. Plug the telescopic rod (2) into the recess on the top of the motor unit (4).
2. Place the hanger (1) onto the telescopic rod (2). When you do this, make sure that
the slight bend in the hanger (1) points forwards.
3. Attach the nylon balloon:
– Pull it over the hanger (1). When you do this, make sure that the side with the hole
line points forwards.
– Pull the small elastic cord at the top over the collar section (9) on the hanger (1).
– Pull the large elastic cord at the bottom over the mounting fl ange (7).
The device is disassembled in the reverse order.
00384_DE-EN-FR-NL_A5_V3.1.indb 13 00384_DE-EN-FR-NL_A5_V3.1.indb 13
13
1 Hanger
2 Telescopic rod with drip protection
1
3 Fan
4 Motor unit
5 Ventilation slots
2
6 Timer (5 – 30 minutes)
7 Mounting fl ange
8 Clip (for adjusting the height)
9 Collar section
Not shown:
3
• Nylon balloon
• 5 x clamps with integrated weight
4
• Mains cable with mains plug
5
EN
01.09.2017 10:26:44 01.09.2017 10:26:44