Use - DS Produkte 00384 Mode D'emploi

EN

Use

CAUTION!
■ Only place the device on a stable, fl at, moisture-resistant and heat-resistant surface.
■ Caution! Hot surface! The motor unit / telescopic rod will become hot during use. You
should therefore not touch it during or shortly after use.
■ It is essential that you follow the care labels for the textiles to be dried!
■ Never cover up the ventilation slots and do not insert any objects into them.
5. Insert the mains plug into an easily accessible socket.
00384_DE-EN-FR-NL_A5_V3.1.indb 14 00384_DE-EN-FR-NL_A5_V3.1.indb 14
14
1. Set the height you want. To do this, open the clip (8), pull
out the telescopic rod (2) and then close the clip (8) again.
2. If you have not already done so, pull on the nylon balloon
(see the "Before Initial Use" chapter, "Assembly" section).
The nylon balloon should sit immediately below the
mounting fl ange (7) so that it can fully infl ate.
3. Pull the garment which is to be pressed over the nylon
balloon and the hanger (1) and do up the buttons if neces-
sary. Make sure that
– the collar is fi tted over the collar section (9) on the
hanger (1),
– any button strip is over the hole line on the nylon balloon,
– the arms of the nylon balloon fi t properly in the sleeves
of the garment and are not twisted or scrunched up,
– all buttons on the garment (including on the sleeves) are
done up.
4. Spread the clamps along the bottom of the garment (at
the front and back in each case on the outsides and in the
middle on the button strip at the front) so that it is weighed
down and will not go out of shape when the nylon balloon
is infl ated.
01.09.2017 10:26:44 01.09.2017 10:26:44