B.A. International Powersurge PS3X Notice D'instruction page 14

Re-assembly of MD:
Only assemble parts with the same serial number
Contra-angle:
• Attach the collar cartridge D to A head (only one direction possible)
until it completely plates (turn the cog until connection if required),
• Insert the head – collar cartridge unit in the G sleeve (connect a clean
tool in the head and turn it slightly so that the cog connects),
• Bring the F lever to the central position, until ratcheting.
Handpiece:
• Insert the J axle in the back K part until ratcheting,
• Connect the front I part by aligning p and X,
• Align the p mark with mark l.
E
Systematically check the condition of the front part by applying axial
traction.
. . .... .. . .. . .. . . .. . .. . .. . .. . .. . .. . . .. .. ... ... ... ... ... ... .. ... ... ... ... ... ... ... ...
Exception : If the After-Sales Service has to replace a part, the serial number may
5
be different.
14
VI.3 - Lubrication
.
5
E
Follow the manual lubrification at the manufacturer's instructions.
Wear appropriate protective clothing (splashes, etc.).
Keep away from all sources of heat or ignition.
In particular: do not smoke. Risk of fire.
After cleaning and before each sterilisation (once a day minimum):
• Remove the rotary instrument,
• Insert the tip to the back of the MD (Fig 7),
• Cover the head of the MD with a soft cloth or paper or a wipe.
• Point the head towards the bottom,
• Spray several times by firmly holding the instrument,
• Wipe excess oil with a cloth or a wipe.
VI.4 - Operational test
• Connect the MD to a micro-motor, point the head towards the bottom.
• Turn the micro-motor on at low speed for 30s. Gradually bring up to
maximum speed.
• Wipe excess oil with a cloth or a wipe
If you notice overheating, irregularities, vibrations, abnormal noises when
x
using the MD, immediately contact your after-sales service.