StreamLight LiteBox Instructions D'utilisation page 4

Four (4) self-tapping 1 1/4" #8 screws (use a 1/8" pilot) are included with each rack and should be sufficient
for most mounting situations. Should your mounting situation require heavier hardware, use #8 machine
screws.
The recommended mounting positions are from vertical to horizontal, but with the lamp end facing up. Allow
enough extra space above the rack for removing and replacing the LiteBox®/FireBox®.
VEHICLE MOUNTED, DIRECT WIRE CHARGE RACK
The 12V DC Direct Wire Charge Cord (#22050) is offered for those who would like to permanently mount a
Streamlight charger in their vehicle.
:
important
1. Never attempt to directly wire any charge rack to a 120 volt AC power source. It is intended for 12-15
volts DC only.
2. Before making electrical connections in a vehicle, keep in mind that a shorted battery can deliver
hundreds of amperes, which can easily start a fire. Make all connections with insulated solder joints,
lugs, or other devices intended for such use. Be sure that your installation is fused. If you install a
separate fuse for your charge rack, 2 amps per unit are recommended.
Before installation, determine if your connection will be switched or non-switched. (Please read Power
Requirements section).
The flashlight is protected from reverse polarity. If connected backwards, the unit simply will not charge.
The positive lead from the charge rack is solid red or has a red stripe. The negative lead is solid black or has
a black stripe.
DUAL FILAMENT BULB (LITEBOX
The LiteBox dual filament lamp assembly features a safety backup beam in case one filament burns out.
®
The light is carefully engineered to produce the same quality beam patterns for either filament. The push
button will alternately choose between the two filaments automatically. If one filament burns out, you
will notice it will require three (3) activations of the switch to light the remaining back up filament. This
indicates the necessity to replace the bulb.
BULB REPLACEMENT (LITEBOX
caution: The inner halogen bulb operates at a high temperature and is pressurized. Allow to cool before
handling. We recommend wearing safety glasses when replacing the bulb.
The PAR-36 lamp assembly used in the LiteBox
bi-pin halogen bulb.
To remove the lamp assembly, stand the flashlight on its back end and pry the black rubber ring from the
lamp housing. Lift out the lamp assembly and carefully disconnect the slip-on terminals.
To replace the halogen bi-pin bulb (tri-pin for dual filament), unscrew the bulb socket from the lamp
assembly. Carefully pull the old bulb straight out from the socket. Align the pins of the new bulb with the
holes in the socket and push until the glass is seated against the socket.
: Avoid touching the new bulb with your skin as perspiration oil can "smoke" the inside of the lens and
note
reflector, as well as deteriorate the bulb glass. If disconnected, reconnect the slip-on terminals; the dual
filament assembly leads are color coded. At this point, if you have the clear "spot" lens, turn on the lantern
and adjust the focus by screwing the socket in or out of the reflector while observing the "spot" against a
wall about ten feet away. The adjustment range is from fully seated to the point where the socket O-Ring
starts to leave the surrounding screw shell. The "flood" lens need not be focused.
Replace the lamp assembly in the lamp housing. Try to dress the lamp wires neatly and make sure the
recess on the reflector fits into its key in the housing. The flood assembly should be rotated to obtain a
desirable pattern angle. Replace the rubber ring.
ONLY)
®
AND FIREBOX
®
/FireBox feature a lamp assembly having a replaceable
® ®
ONLY)
®