Tools - Weka 593 Série Manuel D'installation, D'utilisation Et D'entretien

chlorine treatment (1 kg 100% dissolved chlorine granulate or the same quantity of dissolved chlorine
tablets or chlorine bleach liquor) with a water level of max. 10 cm within a very brief period.
4) In the factory, all inner liners are first folded once lengthways and then folded once in half and rolled
from the middle out. This means that, once unpacked from the polysack (in the pool), the package is
laid at the edge and then rolled into the middle. The second half is then unfolded and pulled to the
opposite end. The liner is then unfolded from the centre and pulled to both sides.
5) The liner wall is then pulled vertically upwards, the upper end laid over the edge of the wooden wall
and fixed in place in the corners with a glue clamp or vice.
6) The corrections to the base and wall which now follow are very important for subsequent wrinkle-free
positioning of the inner liner. The base must be pulled into the grooves so that the external weld seam
which connects the base to the periphery is pushed out as far as possible. It must then be ensured
that the wall liner is pulled vertically upwards and that no diagonal or slanted folds are formed. Should
this be the case, the glue clamps or the vice in this area must be removed and the upper edge
repositioned.
7) It must be ensured that the base is as wrinkle-free as possible before filling commences. If this is not
the case, the base must be smoothed out during the first few minutes of filling. Once the water level
reaches 3–5 cm, correction is no longer possible.
Important: Remain in the pool until the base is smooth.. Should there be any wrinkles in the walls,
these can now be eliminated through adjustment. The wrinkle-free positioning of the liner must be
constantly checked as filling of the pool continues.
8) When the water level is 2/3 full and the walls are wrinkle-free, the liner can be permanently fixed to
the upper, outer edge of the wooden wall. The cover profiles are then mounted to complete the upper
wall. The inlet nozzle and the skimmer are installed when the water is around 5–6 cm below their
opening. Only then is the liner cut appropriately to the opening at this point. Once the inlet nozzle,
skimmer and necessary connection hoses have been installed, the pool can be filled again. For
information on the installation and operation of your filter system, please refer to the enclosed
operating instructions.
•
Cover
When using a cover (not included in the scope of delivery), we recommend using the screw hooks provided to
fasten the tarpaulin. Install as shown in the last diagram. The cover should lie loosely on the surface of the
water, not taut and not pulled over the pool corners.
Information: The covers cannot be used in combination with the top rail and are not suitable for use during
overwintering.

4.5. Tools

Please drill pilot holes for all screw connections to avoid damaging the wood.
The following symbols in the instructions will indicate when this is necessary:
Technische Änderungen vorbehalten! Alle Maßangaben sind ca. Maße.
© Copyright HRB 3662
23