Sennheiser EM 3731 Notice D'emploi page 82

The operating menu
Scan new
Channel list
Scan new
Scan reset
save
DEV 790.800
M
H
z
sync
03.03
BANK
AF COM
esc
CH
Freq. occupied
1.
790.800
MHz
34
Starting the scan
Via the "Scan new" menu, you can scan all frequency banks for free
channels. The last scan result is overwritten.
Before starting the scan, switch all transmitters of your system off,
since channels used by switched-on transmitters will not be displayed
as "free channels".
Turn the jog dial
Press the jog dial
The receiver scans the frequency banks one after the other for free
channels. This can take several minutes. After the scan, a table displays
the number of free channels for each frequency bank and the green
backlighting of the
Note:
You can cancel the scan at any time by pressing the
display changes to the setting mode of the "Scan" menu and the last
scan result is restored.
Turn the jog dial
of free channels.
Press the save
The selected frequency bank is automatically called up in the "B.Ch"
menu.
digital audio
processing
Select a channel from this frequency bank (see "Selecting a frequency
sync
bank and a channel" on page 28).
Note:
B.Ch
After the scan, the channels that are occupied or subject to interference
are marked with a warning triangle and the text
"Tune" menu.
7
until the arrow points to
7
to start the scan.
8
save button flashes.
7
to select a frequency bank with a sufficient number
8
button .
"Scan new".
6
esc button . The
"Freq. occupied" in the