Nikon SF-210 Manuel De L'utilisateur page 31

Open the SF-210's magazine cover, pull back the feed push-plate to the end of its grove, and
hook it in the notch so that it does not spring back to its original position.
Click the double right-arrow button in the "attachment utility" (FDUtility) to move the feed
mechanism to where it is fully visible. If you move the feed mech a nism too far, click the left-
arrow button to move it back. The single-arrow buttons can be used for fi ne adjustments.
Once the feed mech a nism is visible, insert the pegs on the at tach ment into the holes in the
feed mechanism.
Feed-mechanism
attachment
Click the OK button in the "attachment utility" (FDUtility) window to return the feed mech a nism
to its initial po si tion. You are now ready to begin scanning.
Caution
Be sure that the attachment is securely in place. If the attachment is loose, slides may not feed
properly and damage to the SF-210 could result.
When using the feed-mechanism attachment to scan slides with mounts of the same thickness,
open the slide feed slot to leave a gap about one-and-a-half times the thickness of the slide
mounts. If the slide feed slot is too narrow, the attachment may catch on the feeder adjustment
plate, causing feed errors.
13-En