Installation - Nikon SF-210 Manuel De L'utilisateur

3. Installation

Before installing the SF-210, make sure that your scanner is set up in a suitable location, as
described in the documentation pro vid ed with the scanner. The SF-210 should not be used
where:
• the temperature exceeds 35ºC (95ºF) or falls below 10ºC (50ºF)
• it would be subject to condensation or drastic changes in tem per a ture
• the humidity is less than 20% or exceeds 60%
• it would be exposed to direct or refl ected sunlight
• it might be subject to vibration or strong physical shocks
• there is a lot of dust
• it would be exposed to radio interference from other electronic devices
• it would be exposed to water vapor (e.g., from a humidifi er)
• it would be exposed to smoke
Warning: Failure to observe the above precautions could result in fi re or in scanner
malfunction.
When using the SF-210, install the scanner as shown below. There must be suffi cient space
around the scanner to allow the magazine cover to open and to ensure adequate ventilation.
There should be at least 15 cm (6") of space above the unit and 10 cm (4") open to the rear.
Space requirements when the SF-210 is attached are illustrated below.
En-6